USB-A to USB-A 3.0 Cable 1m
$6.95DRV8251 Tiny Motor Driver 3.7A 48V
$3.50USB-A 3.0 Female Breakout Board
$2.50USB-C 3.2 Female Breakout Board
$2.50IEC C13 Female Power Supply Connector with Bolts
$1.25Rocker Switch SPDT
$0.75NEMA17 Stepper Motor Cable for Onboard Stepper Driver 15cm
$1.950.1uF Ceramic Capacitors – 10 Pack
$0.45UPDI Programmer 5V/3.3V
$5.9512 MHz Crystal with 22pF Capacitors
$0.55
Tineato 3226 – ATtiny Microcontroller Board 5V/20MHz
$5.95QWIIC UNO Adapter
$3.95Jumper Wires Male/Female 20 150mm (6″)
$0.95Colored Male Pin Header 40P 0.1″ Red, Yellow, Green, Black, White
$0.50Naneato 3226 – Small ATtiny Microcontroller Board
$6.95Jumper Wires Female/Female 20 150mm (6″)
$0.95UPDI Programmer 5V/3.3V
$5.95USB-A Plug Breakout Board
$1.50Resistor Cheat Sheet PCB (THT and SMD)
$2.95USB-C Female Breakout Board
$1.95
Cheap shipping across the United States!
Free shipping on most orders over $50!
How to Use the All In One ATtiny AVR Programmer
This is an easy to use and versatile programmer for all sorts of AVR microcontrollers. It is great for classic ATtiny’s like the ATtiny85 and…
How to Use the UPDI Programmer
This UPDI programmer is great for programming the new ATtiny 0, 1 and 2 series microcontrollers. These microcontrollers are programmed with UPDI (Unified Program and…
How to Use the Naneato M0 Microcontroller Board
Our Naneato M0 microcontroller board is one of the smallest and still practical boards out there. The entire board is only 16.5mm (0.65″) long and…
How to use the STM32 Keyboard Controller and QMK
This is a general tutorial for how to use the STM32 Keyboard Controller, but it also covers how to use it with QMK. See the…
How to Use the FE1.1s USB Hub
This tutorial is for both of our FE1.1s based USB hub boards. You may want to use our Mini USB Hub board for adding extra…
