UPDI Programmer 5V/3.3V
Product Overview
This UPDI programmer is great for programming the new ATtiny 0, 1 and 2 series microcontrollers. These microcontrollers are programmed with UPDI (Unified Program and Debug Interface) rather than ISP. It combines a CH340E serial converter with the correct components on the RX and TX lines to turn it into a UPDI programmer. It also has a 500mA output 3.3V regulator so you can switch between programming 5V and 3.3V boards.
You can use the Arduino IDE with the megaTinyCore boards package to program any of the newer ATtiny microcontrollers with UPDI support. Simply choose the chip you are programming, and choose “Serial UPDI” as the programmer, any baud speed works. The pins on the end of the board are 2.54mm (0.1″) pitch and can fit standard female jumper wires.
Product Features
- 3.3V or 5V
- 3.3V regulator can put up to 500mA
- Red power indicator LED
- Green active indicator LED
- CH340E
- USB-C
- Dimensions: 1.08″ x 0.59″ x 0.29″ / 27.6mm x 15.1mm x 7.3mm
Documentation
Accessories
These accessories are hand picked by our team to be compatible or very relevant to this product.
Jumper Wires Male/Female 20 150mm (6″)
$1.25In stockUSB-A to USB-C Cable 1m
$5.95In stock
0 reviews for UPDI Programmer 5V/3.3V
Only logged in customers who have purchased this product may leave a review.